News

Wave soldering and reflow soldering of pads in pcb design, pcb manufacturing

2019-08-24 21:12:14 453

In the PCB design, between the two interconnected SMD components, the PCB design should avoid the use of a single large pad, because the solder on the large pad will pull the two components in the middle, the correct way is to put the two components The pads are separated, and the thin wires are connected between the two pads. If the wires are required to pass a large current, several wires can be connected in parallel;

There must be no through holes on or near the pads of the smt parts during PCB design. Otherwise, during solder reflow, the solder on the pads will flow away along the vias, which will result in solder joints, less tin, and possibly flow. Short circuit to the other side of the board;


The type of lead pitch (ie, pad pitch) of the axial device and the jumper should be minimized to reduce the number of adjustments of the device molding and improve the efficiency of the plug-in;

Solder solder lacquer should be added between the pads of the chip IC that requires wave soldering, and the tin pad should be designed at the last leg;


When the PCB design is not specifically required, the component hole shape, the pad and the component foot shape must match, and the symmetry of the pad with respect to the center of the hole is ensured (the square component foot is provided with a square component hole, a square pad; the circular component foot is matched Round element holes, round pads) to ensure that the solder joints are full of tin;

For components that need to be soldered after the tin furnace, the pad should be turned away from the tin position, the direction is opposite to the direction of the tin, and the width of the hole is 0.5 to 1.0 mm to prevent the hole from being blocked after the peak;

Increase the copper skin and increase the attractive force of the side pins to facilitate self-alignment of reflow soldering.


Juding Circuit Technology Co., Ltd. is a high-tech enterprise integrating PCB design, PCB prototype production and PCB mass production. It can satisfy the exquisite process of 1-34 layers, and Juding Circuit Technology is trustworthy.