PCB prototype manufacturer: Rogers local mixed plate structure
The patented technology of the utility model discloses a Rogers partial hybrid pressing high-frequency circuit board structure, including a Rogers partial mixed pressure fixing plate, and the bottom of the Rogers partial mixed pressure fixing plate is in contact with the top of the mounting plate, and the top of the Rogers partial mixed pressure fixing plate A high-frequency circuit board is fixedly connected, and fixed rods are fixedly connected to both sides of the top of the mounting plate. The tops of the top of the Rogers partial mixed-pressure fixing plate are fixedly connected with a vertical rod, and the surface of the middle part of the vertical rod is fixedly sleeved with a pressure sleeve. The right side of the pressure sleeve is fixedly connected to the side of the high frequency circuit board.
The Rogers partial mixed high-frequency circuit board structure pulls the limit sleeve to the outside while rotating the telescopic rod, so that the limit sleeve is smoothly sleeved on the surface of the fixed rod, and the U-shaped card is driven by the compression spring Simultaneously with the engagement of the card bumps, the threaded rod is rotated, and the thread pushing principle is adopted to drive the pressing plate to restrain the Rogers partial pressure fixing plate, thereby achieving the effect of disassembling the high frequency circuit board at any time, and effectively Improve the service life of high frequency circuit boards.
Rogers local mixed high-frequency circuit board is a high-strength stable high-frequency circuit board. Generally speaking, high-frequency can be defined as an electronic product with a frequency above 1 GHz, which tends to be complicated and complicated. The contact distance of the components is reduced, and the speed of signal transmission is relatively increased. This is accompanied by an increase in the number of wires and a reduction in the length of the wiring between the points. These require high-density line configuration and micro-hole technology. Achieve high frequency goals.
At present, the existing Rogers partial mixed high-frequency circuit board is generally soldered, and the Rogers local mixed high-frequency circuit board is directly soldered on the mounting circuit board, which is inconvenient for Rogers local high pressure. The frequency circuit board is cleaned and installed and repaired, which reduces the service life of the Rogers local mixed high frequency circuit board.
PCB manufacturer from China: Juding Circuit Technology, providing PCB board manufacturing, multi-layer PCB board, TG board, HDI board, Rogers board, 1-3-4 layer board manufacturing production,Feel free to contact the staff to find out more!